Konica Minolta REGIUS 110 Service Manual page 195

Second
Grounding cable
Front Back Side
CN2
CN1
CN9
A
JP61
CN11
First Front Back Side
Second Front Back Side
Chapter 5 Disassembly and Assembly
4
Remove the connector and the grounding cable
from the optical unit.
•
LMC
•
CN1 (ACN1: cable)
•
CN2 (ACN2: cable)
•
CN9 (ACN9: cable)
•
Eraser unit junction cable
•
JJ61 (JP61: cable)
•
Grounding cable
When removing the connector, hold a notch
on the connector without pulling a cable.
Caution
Giving a strong pull to the cable may cause
it to be broken.
5
Remove the snap ties and other parts.
•
Snap ties at 3 locations
•
A: wiring band at a location (cut it off)
6
Remove the connector (CN11) from the CIU.
•
CN11 (CCN11: cable)
When removing the connector, hold a notch
on the connector without pulling a cable.
Caution
Giving a strong pull to the cable may cause
it to be broken.
7
Cut off the wiring band (5 locations) retaining the
cable removed in Step
When installing, position the white mark on the cable to
the position A in the figure. In addition, when fixing,
make sure that the cable is located outside at the
positions A, B, D and E.
6.
5-75