Konica Minolta REGIUS 110 Service Manual page 60

Chapter 3 Troubleshooting
Error code
S E
06008 06023 06038 Justifier HP sensor error
06009 06024 06039 Justifier motor control error
06010 06025 06040 Justifier HP sensor error
06011 06026 06041 Justifier motor control error
References for response method
•
See "2.5.2 Receiver unit (Page 2-12)"
sensor.
•
See "2.5.8 Framework (Page 2-19)"
•
See "5.4.1 Replacing the Justifier HP Sensor (Page 5-40)"
HP sensor.
•
See "5.4.3 Replacing the Justifier Motor (Page 5-42)"
•
See "5.10.2 Replacing the MDU (Page 5-116)"
3-6
Description of the error
I
(when moving to HP 3)
Justifier HP sensor did not go
ON when the justifier guide was
moving from the minute opening
position to the home position.
(when moving to HP 3)
There was a trouble with the
motor control when the justifier
guide was moving from the
minute opening position to the
home position.
(when moving to minute
opening position)
Justifier HP sensor did not go
OFF when the justifier guide
was moving from the home
position to the minute opening
position.
(when moving to minute
opening position 2)
There was a trouble with the
motor control when the justifier
guide was moving from the
home position to the minute
opening position.
for the position of the justifier motor and the justifier HP
for the position of the MDU.
Response
(References to replacement methods are
listed at the end of the table.)
Confirm following and replace the faulty
parts.
•
Justifier HP sensor
•
Sensor wire: JP41 ~ MCN3 (MDU)
•
Justifier motor
•
Motor wire: JJ50 ~ MCN5 (MDU)
•
MDU
Confirm following and replace the faulty
parts.
•
Justifier motor
•
Motor wire: JJ50 ~ MCN5 (MDU)
•
MDU
Confirm following and replace the faulty
parts.
•
Justifier HP sensor
•
Sensor wire: JP41 ~ MCN3 (MDU)
•
Justifier motor
•
Motor wire: JJ50 ~ MCN5 (MDU)
•
MDU
Confirm following and replace the faulty
parts.
•
Justifier motor
•
Motor wire: JJ50 ~ MCN5 (MDU)
•
MDU
for the procedure to replace the justifier
for the procedure to replace the justifier motor.
for the procedure to replace the MDU.