Konica Minolta REGIUS 110 Service Manual page 163

13
See " Installation Procedures (Page 5-8)"
and Insertion Unit" to install the insertion unit and exterior panel.
Now, you have finished with the procedures to replace the justifier motor.
5
Remove the justifier motor.
•
4 screws (M4 x 12)
6
Remove the gear.
•
2 setscrews
7
Install the gear on the new justifier motor.
•
2 setscrews
Fix the gear, fitting the edge surfaces of it and the
motor shaft.
8
See Step 5
motor mount board.
•
4 screws (M4 x 12)
Important
9
Temporarily secure the motor mount board to the
main unit.
Setscrew
•
3 hex/Phillips-head screws (M4 x 8)
10
See "6.1 Adjust Justifier Belt Tension (Page 6-2)"
to adjust the belt tension.
Setscrew
11
Connect the connector (JP50) that was removed
in Step 3.
12
Install the exterior frame (front) that was removed
in Step 2.
•
4 screws (M4 x 8)
in "5.2.3 Removing/Installing the Exterior Panel
Chapter 5 Disassembly and Assembly
to install the justifier motor on the
Make sure the connector is in the right
direction when installing the motor.
5-43