Konica Minolta REGIUS 110 Service Manual page 245

A
Chapter 5 Disassembly and Assembly
8
Remove the transporter motor.
•
4 hex/Phillips-head screws (M4 x 12)
•
1 hexagon nut
•
1 washer
9
Remove the gear.
•
2 setscrews
10
Secure temporarily the gear to the new
transporter motor.
•
2 setscrews
11
See Step 8 to install the transporter motor on the
bracket.
•
4 hex/Phillips-head screws (M4 x 12)
Make sure the connector is in the right
direction when installing the motor.
Important
12
Adjust the position of the gear and fix it.
Fix the gear, positioning the Surface A shown in the
figure.
13
See Step 7 to install the transporter motor unit
assembly.
•
4 screws (M4 x 8)
14
Connect the connector (JP52) that was removed
in Step 6.
15
Install the right side tumbler (upper) that was
removed in Step 5.
•
2 screws (M4 x 8)
16
See Step 4 to secure the cable to the transporter
unit assembly with the wiring band.
5-125