First Front Back Side
21
See
"
Installation Procedures (Page 5-8)"
and Insertion Unit"
to install the insertion unit and exterior panel.
Now, you have finished with the procedures to replace the cable bear.
15
Connect the serial cable connector to the CIU.
•
CN11 (CCN11: cable)
CN11
16
See
Step 3
with the connectors (JP13, JJ14).
17
See
Step 8
on the holding plate.
•
1 screw (M3 x 6)
18
Make sure that the cable bear unit assembly has
been mounted appropriately.
Move the holding plate with the receiver fully down to
make sure that the cable
receiver and the receiver base.
19
See
Step 4
optical unit and fix it using the snap ties and the
wiring band.
•
LMC
•
CN1 (ACN1: cable)
•
CN2 (ACN2: cable)
•
CN9 (ACN9: cable)
•
Eraser unit junction cable
•
JJ61 (JP61: cable)
•
Grounding cable
20
Install the electric component mount panel that
was removed in
•
8 hex/Phillips-head screws (M4 x 8)
in
"5.2.3 Removing/Installing the Exterior Panel
Chapter 5 Disassembly and Assembly
to connect the cable bear side cables
to install the cable bear unit assembly
bear
does not contact the
and
Step 5
to connect the cable to the
Step
2.
5-77