Chapter 5 Disassembly and Assembly
3
Remove the connectors in the below figure to remove the cables secured to the transformer
unit assembly with the wiring band and clamps.
When removing the connector, hold a notch on the connector without pulling a cable. Giving a
strong pull to the cable may cause it to be broken.
Caution
Removing the transformer unit assembly will remove the cables expressed with heavy lines in the figure,
which are kept attached to the unit. Remove any other cable than the above, which is attached to the unit.
CN2/PCN2
Tap Switching
Connector
JJ21
JP10
•
Ties
•
A: wiring band (cut them off)
•
B: snap ties (cut them off)
•
C: snap ties (remove them)
•
Transformer cables
•
JJ1 (JP1A: cable)
•
JP2 (CN2: cable)
•
JJ3 (JP3: cable)
•
JJ21 (tap switching connector)
JJ21 must be removed from the clasp.
•
PCU
•
CN2 (PCN2: cable)
•
Interlock switch
•
JJ10 (JP10: cable)
5-110
JJ3
CN2/JP25
JJ2
JP49
A
A
A
A
CN2/JP27
2 Wires at Bottom
of Interlock Relay 1
C
A
B
B
JJ1
First Front Side
•
Interlock relay 1
•
2 pieces in the lower side (left: brown,
right: black)
•
Digital power supply
•
CN2 (JP25: cable)
•
Digital power supply cooling fan cable
•
JP49 (JJ49: cable)
•
Analog power supply
•
CN2 (JP27: cable)
•
Halogen power supply
•
CN1 (HCN1: cable)
CN1/HCN1