Konica Minolta REGIUS 110 Service Manual page 178

Chapter 5 Disassembly and Assembly
11
See " Installation Procedures (Page 5-8)"
and Insertion Unit"
Now, you have finished with the procedures to replace the justifier guide unit assembly.
5-58
6
8
Second Front Side
9
10
to install the first front panel.
Eject the justifier guide unit assembly.
7
Replace the parts.
Checking the Justifier Guide Unit Assembly
after Assembled
Incline the justifier guide unit assembly to make sure
that the guide can be moved by its own weight.
If it cannot, the justifier shaft has not been assembled
parallel to the guide.Adjust the justifier shaft by
tightening or loosening the setscrew.
Fixing the Cable
If the cable has been unplugged from the
justifier guide, align the white mark with the
Important
fixing position, then fix the cable using the
wiring band.
See Step 5 and Step 4 to install the justifier guide
unit assembly.
•
Belt presser plate: 1 tapping screw (M4 x 10)
•
Justifier base: 2 screws (M4 x 8)
Press the justifier guide unit assembly upward to fix it.
See Step 2 to install the connector (JJ18) and the
wiring band.
Align the white mark on the cable with the
fixing position, then fix the cable using the
Important
wiring band.
See "6.1 Adjust Justifier Belt Tension (Page 6-2)"
to adjust the belt tension.
in "5.2.3 Removing/Installing the Exterior Panel