5
•
6
•
7
•
1mm
8
•
9
•
Dowel
A
Dowel
Chapter 5 Disassembly and Assembly
Remove the receiver motor.
4 hex/Phillips-head screws (M4 x 8)
Remove the gear.
2 setscrews (M4 x 5)
Install the gear on the new receiver motor.
2 setscrews (M4 x 5)
When installing, make sure the clearance between the
motor main unit and the gear is 1 mm.
See
Step 5
to install the receiver motor on the
receiver motor mount board.
4 hex/Phillips-head screws (M4 x 8)
Make sure the connector is in the right
direction when installing the motor.
Important
Install the receiver motor mount board.
2 hex/Phillips-head screws (M4 x 8)
Press the board rightward until it reaches the dowel,
then fix it by pressing upward so as not to form any
clearance at A (between the edge of the motor and the
pulley) shown in the figure.
5-51