Konica Minolta REGIUS 110 Service Manual page 269

Second Front Side
5 5.5mm
8
Confirm if it is possible to slide in the press down
adjustment jig in-between the push plate and the
shaft.
Slide in the jig along the indentation of the plate as
shown in the figure.
OK: Can insert.
Insertion direction
Thin Thick
OK OK
OK NG
NG NG
It is in following specified value if it is appropriate.
Measurement Distance between the push plate
and the shaft when the press down
is performed on the 14 x 17 inch
cassette
Specified 5 - 5.5 mm
value
Go to Step 11 if you do not need to change the
Pressing Amount.
9
Change the value for the press down if the
distance between the push plate and the shaft is
not within the specified value, and reconfirm.
1. Click the [Move To HP] button.
2. Change the pressing amount.
3. Click the [Pressing Position] button.
4. Confirm if the press down adjustment jig can be
inserted again.
Repeat until the distance come within the specified value.
There are around 0.15 mm error in the push
down.
Note
Chapter 6 Adjustment
NG: Cannot insert.
Status of press down
Press down is weak
Appropriate
Press down is strong
6-17