Konica Minolta REGIUS 110 Service Manual page 169

10
See " Installation Procedures (Page 5-8)"
and Insertion Unit" to install the insertion unit and exterior panel.
Now, you have finished with the procedures to replace the receiver HP sensor.
Chapter 5 Disassembly and Assembly
6
Install the new receiver HP sensor on the receiver
sensor mount board.
•
1 screw (M4 x 15)
7
Connect the cable to the receiver HP sensor.
•
Connector (JP43)
8
Install the receiver sensor mount board that was
removed in Step 3.
•
1 hex/Phillips-head screws (M4 x 8)
9
Install the exterior frame (front) that was removed
in Step 2.
•
4 screws (M4 x 8)
in "5.2.3 Removing/Installing the Exterior Panel
5-49