Konica Minolta REGIUS 110 Service Manual page 58

Chapter 3 Troubleshooting
First Front Back Side
3-4
6
Eject the cassette if the cassette is still in the
equipment.
When the push plate is not at the read
position
1. See "
"5.2.3 Removing/Installing the Exterior Panel and
Insertion Unit", and remove the first font back panel.
2. Move the push plate to the read position by rotating A
in the image (drive shaft holder).
3. Eject the cassette.
See the instruction manual on how to eject the
cassette.
4. See "
A
"5.2.3 Removing/Installing the Exterior Panel and
Insertion Unit", and attach the first font back panel.
7
Turn ON the power supply circuit breaker.
8
Press the "operation" switch.
Equipment will start up and initialization will be
performed.
Removal Procedures (Page 5-6)"
Installation Procedures (Page 5-8)"
of the
of the