Chapter 5 Disassembly and Assembly
Left Side
•
C: screw (M3 x 6)
•
D: tapping screw (M4 x 10)
Second Front Side
10
See
"
Installation Procedures (Page 5-8)"
and Insertion Unit"
Now, you have finished with the procedures to replace the cleaning unit.
5-132
C
C
to install the insertion unit and exterior panel.
C
C
6
Adjust the wire tension.
Make sure that the clearance between the cushion
rubber on the brush unit and the subscan base is a
value from 0 to 0.5 mm as a result of a visual
inspection.
Loosen the setscrew on the roller in the upper right
side and move it upward and downward to adjust the
tension.
After adjustment, move the knob to check the brush
unit for normal operation.
7
See
Step 4
to install the exterior frame (left).
•
A: 3 hex/Phillips-head screws (M4 x 8)
•
B: 13 screws (M4 x 8)
8
See
"
Installation Procedures (Page 5-10)"
"5.2.4 Removing/Installing the Second Front
Door"
to install the second front panel.
9
Install the exterior frame (front) that was removed
in
Step
2.
•
4 screws (M4 x 8)
in
"5.2.3 Removing/Installing the Exterior Panel
D
in