Konica Minolta REGIUS 110 Service Manual page 149

Sensor 2 (LPB1)
J34
J33
Sensor 1 (LPB2)
Chapter 5 Disassembly and Assembly
3
Remove the shutter unit assembly.
•
5 tapping screws (M4 x 10)
4
Remove the sensor cover.
•
2 screws (M4 x 8)
5
Remove the insertion slot detection sensors
(LPB).
•
Insertion slot detection sensor 1: 1 screw (M3 x 6)
•
Insertion slot detection sensor 2: 1 screw (M3 x 6)
6
Unplug the cables from the insertion slot
detection sensors (LPB).
•
Insertion slot detection sensor 1: connector (J34)
•
Insertion slot detection sensor 2: connector (J35)
When removing the connector, hold a notch
on the connector without pulling a cable.
Caution
Giving a strong pull to the cable may cause
it to be broken.
7
Connect the cables to the new insertion slot
detection sensors (LPB).
8
Install the insertion slot detection sensors (LPB).
•
Insertion slot detection sensor 1: 1 screw (M3 x 6)
•
Insertion slot detection sensor 2: 1 screw (M3 x 6)
9
Install the sensor cover that was removed in
4.
•
2 screws (M4 x 8)
Step
5-29