Konica Minolta REGIUS 110 Service Manual page 141

8
See " Installation Procedures (Page 5-8)"
and Insertion Unit" to install the insertion unit and exterior panel.
Now, you have finished with the procedures to change the mounting location of the operation unit.
Chapter 5 Disassembly and Assembly
4
Remove the operation unit.
•
4 tapping screws (M4 x 10)
5
Place the operation unit at the position where the
dummy operation unit was placed.
•
4 tapping screws (M4 x 10)
6
Follow the figure to wire the cables to the
operation unit.
•
Clamps for 4 locations
7
Install the dummy operation unit.
•
4 tapping screws (M4 x 10)
Install the unit in a direction so that the
bottom of the "Cassette loaded/Do not sit
Important
on" label is the operation side.
in "5.2.3 Removing/Installing the Exterior Panel
5-21