Konica Minolta REGIUS 110 Service Manual page 234

Chapter 5 Disassembly and Assembly
First Front Back Side
10
See " Installation Procedures (Page 5-8)"
and Insertion Unit"
Now, you have finished with the procedures to replace the cooling fan.
5-114
JJ62
to install the first front back panel.
3
Remove the connector (JJ62).
When removing the connector, hold a notch
on the connector without pulling a cable.
Caution
Giving a strong pull to the cable may cause
it to be broken.
4
Remove the fan unit assembly.
•
1 screw (M4 x 8)
5
Remove the cooling fan.
•
1 hex/Phillips-head screw (M3 x 20)
6
Install the new cooling fan.
•
1 hex/Phillips-head screw (M3 x 20)
7
See Step 4 to install the fan unit assembly.
•
1 screw (M4 x 8)
8
Connect the connector (JJ62) that was removed
in Step 3.
9
Install the circuit board cover that was removed in
Step 2.
•
3 screws (M3 x 6)
in "5.2.3 Removing/Installing the Exterior Panel