Konica Minolta REGIUS 110 Service Manual page 266

Chapter 6 Adjustment
Adjustment Block
A B
Top Side
E
Bottom Side
F
15
See " Installation Procedures (Page 5-14)"
install the optical unit.
6-14
Adjust the roller position
Adjust the roller position by performing
the top and bottom of the roller.
C D
5
F
6
G
Adjust the sensor position
8
E
9
G
10
11
12
13
14
4
Adjust the roller position by turning the
adjustment screw (E in the figure) so it will touch
B of the adjustment block.
•
1 each hex/Phillips-head screw (M3 x 20)
•
1 hexagon nut each
Confirm that it is not touching A of the adjustment
block.
Fix it by tighten the hex nut of the adjustment
screw (E in the figure).
Be careful that the adjustment screw do not
turn when tightening the hex nut.
Important
7
Turn the roller and confirm that the roller does not
touch A of the adjustment block in the center part.
Continue with the adjustment of the sensor position.
Loosen the fixing screw (F in the figure) for the
sensor mount board.
•
1 each hex/Phillips-head screw (M3 x 10)
Remove the cables from the sensor, and connect
the sensor status detection jig.
Connect the USB cable from the sensor status
detection jig.
Adjust the position of the sensor mount board by
turning the adjustment screw (G in the figure) so
the sensor will come ON when C of the
adjustment block is touching the roller.
•
1 each hex/Phillips-head screw (M3 x 10)
•
1 hexagon nut each
Also confirm that the sensor is OFF with B of the
adjustment block.
Fix each sensor mount board by tightening the
fixing screw (F in the figure) after adjusting the
sensor position.
Be careful not to shift the adjusted position
while fixing.
Important
Close the number 2 eraser cover once the
adjustments are finished.
•
- 1 screw (M4 x 12)
Install the hot-cathode tube lamp that was
removed in Step 2.
Attach it so the transparent face will be on the surface.
in "5.2.5 Removing/Installing the Optical Unit"
Step 4 - Step 6 at
to