Chapter 5 Disassembly and Assembly
5-32
4
Remove the bracket from the shutter open
detection sensor.
•
1 screw (M4 x 8)
5
Remove the shutter open detection sensor.
6
Install the new shutter open detection sensor on
the bracket.
7
Install the bracket that was removed in
•
1 screw (M4 x 8)
8
Install the shutter unit assembly that was
removed in
Step
3.
•
5 tapping screws (M4 x 10)
Press it in a direction of the arrow shown in the figure
to fix it.
9
Use a 0.2 mm-spacer (film) to check the clearance
between the lock cam and the stopper block.
If the clearance is any other value than 0.2 mm, adjust
the position of the stopper block.
Step
4.