Konica Minolta REGIUS 110 Service Manual page 129

First Front Back Side
Installing the First Front Panel
First Front Side
Installing the First Front Back Panel
First Front Back Side
Installing the First Front Back Panel
Second Front Back Side
Now, you have finished with the procedures to install the exterior panels and the insertion unit.
Chapter 5 Disassembly and Assembly
3
Install the circuit board cover.
•
3 screws (M3 x 6)
4
Install the first front panel.
•
6 screws (M4 x 8)
Hold the bottom part of the first front panel with both
hands, and install it by inserting the top part of panel
into the panel.
5
Close the second front door.
6
Install the first front panel.
•
7 screws (M4 x 8)
Hold the bottom part of the first front back panel with
both hands, and install it by inserting the top part of
panel into the panel.
7
Install the first front back panel.
•
6 screws (M4 x 8)
•
1 spacer for each screw (for 4 locations excluding the
middle one)
5-9