Konica Minolta REGIUS 110 Service Manual page 215

JP1
Second Front
First Front Side
B
B
A
B
Second Front Back Side
White
Black
Black White
4
Remove the connector (JP1) from the first front
side.
Caution
5
Remove the grounding cable from the second
front side.
•
1 hex/Phillips-head screw (M5 x 10)
Back Side
6
Remove the exterior frame (right).
•
A: 3 hex/Phillips-head screws (M4 x 8)
•
B B: 14 screws (M4 x 8)
Remove all screws.
B
7
Remove the noise filter and the circuit protector
unit assembly.
•
Noise filter
•
2 screws (M4 x 8)
•
Grounding cable: 1 screw (M4 x 8)
•
Circuit protector unit assembly
•
2 screws (M4 x 8)
8
Replace the parts.
•
Circuit breaker cover
•
1 screw (M4 x 8)
•
Inlet
•
2 screws (M3 x 6)
Install the circuit protector (power supply circuit
Blue
breaker) with the ON side up.
Yellow
Install the inlet with the ground side facing to the left.
Chapter 5 Disassembly and Assembly
When removing the connector, hold a notch
on the connector without pulling a cable.
Giving a strong pull to the cable may cause
it to be broken.
5-95