Konica Minolta REGIUS 110 Service Manual page 109

Insertion Slot Detection Sensor 1
Chapter 4 Confirming Operation Using Service Tool
Initialization of Justifier Motor
The following operation is necessary only when
performing an initialization of the justifier motor.
It will stop with the message, [Uploading...] displayed
when the [Initialization] button for justifier motor is
clicked.
Block the light of the insertion slot detection sensor 1
using your hands.
Justifier motor will perform the same
operation as Adjustment of Justifier Motor
Note
in "Adjustment" panel, therefore stops and
waits for the detection of the cassette. That
is the reason for the need of this operation.
4
Click the [Move To HP] button.
Receiver will move to the home position.
Once the move is completed without any problem, a
message [Move To HP ... OK] is displayed in the
[Information] area and [Position 1] button is enabled.
5
Click the [ ] button.
Position 1
Receiver will move to the home position.
Once the move is completed without any problem, a
message [Position 1 ... OK] is displayed in the
[Information] area, and [Move to HP] button and
[Position 2] button are enabled.
Likely, the [Move To HP] button and [Transportation
Position] button will be enabled after it moved to the
second falling position by clicking the [Position 2]
button.
Also, the [Move To HP] button and [Position 1] button
will be enabled after it moved to the transportation
position by clicking the [Transportation Position] button.
4-7