Chapter 5 Disassembly and Assembly
15
See
"
Installation Procedures (Page 5-8)"
and Insertion Unit"
Now, you have finished with the procedures to replace the noise filter and the circuit protector unit.
5-96
9
See
assembly.
•
•
Move the noise filter in the direction of the arrow in the
figure and fix it.
10
See
•
•
11
See
inlet to the frame.
•
12
Connect the connector (JP1) that was removed in
Step
13
Connect the CIU connector (CN5) that was
removed in
•
14
Connect the cooling fan connector (JJ62) that
was removed in
in
to install the insertion unit and exterior panel.
Step 7
to install the locking pin unit
Noise filter
•
2 screws (M4 x 8)
•
Grounding cable: 1 screw (M4 x 8)
Circuit protector unit assembly
•
2 screws (M4 x 8)
After installing, make sure that circuit
protector has been switched to OFF.
Caution
Step 6
to install the exterior frame (right).
A: 4 hex/Phillips-head screws (M4 x 8)
B: 12 screws (M4 x 8)
Step 5
to connect the grounding cable of the
1 hex/Phillips-head screw (M5 x 10)
4.
Step
3.
CN5 (CCN5: cable)
Step
2.
"5.2.3 Removing/Installing the Exterior Panel