Alarm Relay Contact Wire Specifications For The Srx5600 Services Gateway; Console Port Cable And Wire Specifications For The Srx5600 Services Gateway; Connector Pinouts For The Srx5600 Services Gateway Routing Engine Ethernet Port - Juniper SRX5600 Hardware Manual

Alarm Relay Contact Wire Specifications for the SRX5600 Services Gateway

Table 51 on page 183 lists the specifications for the wires that connect to the alarm relay contacts.
Table 51: Cable and Wire Specifications for Alarm Interfaces
Port
Alarm relay contacts
Console Port Cable and Wire Specifications for the SRX5600 Services
Gateway
Table 52 on page 183 lists the specifications for the cable that connects a CONSOLE port on the Routing
Engine to a management console.
Table 52: Cable and Wire Specifications for Routing Engine Management and Alarm Interfaces
Port Cable Specification
Routing Engine RS-232 (EIA-232)
console or auxiliary serial cable
interface
RJ-45 Connector Pinouts for the SRX5600 Services Gateway Routing Engine
Ethernet Port
The port on the Routing Engine labeled ETHERNET is an autosensing 10/100-Mbps Ethernet RJ-45
receptacle that accepts an Ethernet cable for connecting the Routing Engine to a management LAN (or
other device that supports out-of-band management).
pinout.
Table 53: RJ-45 Connector Pinout for the Routing Engine ETHERNET Port
Pin
1
Cable Specification
Wire with gauge between 28-AWG and 14-AWG (0.08
2
and 2.08 mm )
Cable/Wire Supplied
One 6-ft (1.83-m) length
with RJ-45/DB-9
connectors
Signal
TX+
Maximum
Length
6 ft (1.83 m)
Table 53 on page 183 describes the RJ-45 connector
Cable/Wire Supplied
No
Receptacle
RJ-45/DB-9
male
183