SRX550 High Memory Services Gateway Hardware Guide
Related
Documentation
RJ-45 Connector Pinouts for the SRX550 High Memory Services Gateway Ethernet
Port
70
Table 33: Cable and Wire Specifications for Ports and Alarm Interfaces
Cable
Port
Specification
Console
RS-232 (EIA-232)
serial cable
USB
USB
console
Ethernet
Category 5 cable or
equivalent suitable
for 100Base-T
operation
NOTE:
The Auxiliary port is not supported on the SRX550 High Memory
Services Gateway.
RJ-45 Connector Pinouts for the SRX550 High Memory Services Gateway Ethernet
Port on page 70
RJ-45 Connector Pinouts for the SRX550 High Memory Services Gateway Console
Port on page 71
The port on the front panel labeled ETHERNET is an autosensing 10/100/1000-Mbps
Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the services
gateway to a management LAN (or other device that supports out-of-band management).
Table 34 on page 70
describes the RJ-45 connector pinouts for the Ethernet port.
Table 34: RJ-45 Connector Pinouts for Services Gateway Ethernet Port
Pin
1
2
3
4
5
6
Cable/Wire Supplied
One 6-ft (1.83-m) length
with DB-9/DB-9
connectors
One 6-ft (1.83-m) length
with Mini-B and Type A
plugs
One 15-ft (4.57-m) length
with RJ-45/RJ-45
connectors
Signal
TX+
TX-
RX+
Termination network
Termination network
RX-
Copyright © 2016, Juniper Networks, Inc.
Maximum
Device
Length
Receptacle
6 ft (1.83 m)
RJ-45
6 ft (1.83 m)
Mini-B USB
Socket
328 ft
RJ-45
(100 m)
autosensing