Flushing The Hydraulic System - Toro Groundsmaster 7210 Service Manual

Priming the Hydraulic Pumps (continued)

Flushing the Hydraulic System

Groundsmaster 7210
16222SL Rev C
g035022
1. Starter motor
2. Starter solenoid
Note: A blue wire connects to the starter motor solenoid B+ terminal
53). It is not necessary to remove this blue wire from the solenoid terminal
for hydraulic pump priming.
3. Connect the remote starter switch electrical leads to the starter motor
solenoid B+ terminal and positive post of the battery.
4. Engage the remote starter switch and crank the starter for 30 seconds to
prime the hydraulic pumps. Wait for 30 seconds to allow the starter motor and
starter solenoid to cool. Repeat the cranking procedure for the second time.
5. Disconnect the remote starter switch leads from the starter motor solenoid
terminal and positive post of the battery.
Flush the hydraulic system whenever there is a severe component
failure or the system is contaminated (for example, the fluid appears
milky, black, or contains metal particles).
If a component failure occurs in the traction circuit; refer to the
Traction Circuit (Closed Loop) Component Failure (page 4–12)
information regarding the importance of removing contamination
from the traction circuit.
1. Ensure that the hydraulic fluid is at normal operating temperature by
operating the machine for at least 20 minutes.
Figure 53
3. B+ terminal
IMPORTANT
IMPORTANT
Page 4–59 Hydraulic System: Service and Repairs
(Figure
for