Lift Control Manifold Solenoid Valve Coils - Toro Groundsmaster 7210 Service Manual

Lift Control Manifold Solenoid Valve Coils

Removing the Lift Control Manifold Solenoid Valve Coils
Installing the Lift Control Manifold Solenoid Valve Coils
Electrical System: Service and Repairs
g035040
1. Solenoid nut
2. Coil
3. Solenoid Valve
4. Deck lift manifold
You can replace a hydraulic solenoid valve coil on the deck lift manifold
182) without opening the hydraulic system.
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, shut off the engine, and remove the key from the key switch.
2. Locate the solenoid valve coil that you replace.
3. Raise the operator seat to get access to the deck lift manifold
for the location of solenoid coils on the deck lift manifold.
4. Disconnect the wire harness electrical connector from the solenoid valve
coil that you replace.
5. Remove the nut from the hydraulic valve.
6. Slide the solenoid coil from the valve.
7. Clean any corrosion or dirt from the valve.
1. Slide the coil assembly onto the hydraulic valve.
2. Install the nut onto the valve and torque the nut to 6.8 N∙m (5 ft-lb).
Note: Do not overtighten the nut.
3. Connect the machine wire harness connector to the solenoid coil.
4. Lower and secure the seat.
Figure 182
5. Zero-leak plug
6. Solenoid valve
7. Coil
8. Coil nut
Page 5–58
(Figure
(Figure 182)
Groundsmaster 7210
16222SL Rev C