Toro Groundsmaster 7210 Service Manual page 314

g033716
1. Right spindle grease fitting
Removing the Blade Spindle
Cutting Deck: Service and Repairs
2. Center spindle grease fitting
g033714
1. Idler arm (right)
2. 1/2 inch square drive
1. Park the machine on a level surface, raise the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
Support the cutting deck so that it cannot fall accidentally.
2. Lift the footrest to get access to the top of the cutting deck and support the
footrest with the prop rod.
3. Remove the belt covers from the top of the cutting deck.
Note: When removing the deck drive belt, use the breaker bar in the idler arm
square drive holes to rotate the idler pulley away from the belt
Figure 220
Figure 221
3. 3/8 inch square drive
Page 7–10
3. Left spindle grease fitting
(Figure
Groundsmaster 7210
16222SL Rev C
221).