Lift Cylinder - Toro Groundsmaster 7210 Service Manual

Lift Cylinder

g033629
1. Grease fitting
2. Retaining ring
3. O-ring
4. Straight fitting (2 each)
5. O-ring
6. Hydraulic hose assembly
7. O-ring
8. O-ring
9. Hydraulic hose
Removing the Lift Cylinder
Hydraulic System: Service and Repairs
10. O-ring
11. Tee fitting
12. O-ring
13. O-ring
14. Straight fitting
15. O-ring
16. Lift cylinder
17. Locknut
18. Pivot pin
Before disconnecting or doing any work on the hydraulic system,
release all the pressure in the system; refer to
from the Hydraulic System (page
1. Park the machine on a level surface, lower the cutting deck (or implement),
shut off the engine, set the parking brake, and remove the key from the
key switch.
2. Clean the hydraulic hose ends and fittings on the lift cylinder to prevent
contaminants from entering into the hydraulic system.
Figure 127
19.
20.
21.
22.
23.
24.
25.
WARNING
4–11).
Page 4–124
Flange-head screw
Bolt (2 each)
Lock washer (2 each)
Lift control manifold
O-ring
90° hydraulic fitting
O-ring
Releasing Pressure
Groundsmaster 7210
16222SL Rev C