Service And Repairs; Blade Stopping Time - Toro Groundsmaster 7210 Service Manual

Service and Repairs

Do not start the engine and engage the PTO switch when the PTO driveshaft is
disconnected from the cutting deck (or implement). If you start the engine and the PTO
shaft is allowed to rotate, serious personal injury and machine damage could result.
Before disconnecting the PTO driveshaft from the cutting deck (or implement), remove
the fuse F1 (15 A) from the fuse block to prevent the PTO clutch from engaging
accidentally.
Do not work on the cutting deck with the engine running.
Always shut off the engine and remove the key from the key switch before working
on the cutting deck.

Blade Stopping Time

Cutting Deck: Service and Repairs
WARNING
CAUTION
g034748
1. Fuse F1 (15 A)
2. Fuse block
Before servicing the cutting deck, remove the fuse F1 (15 A) from the fuse block
(Figure 216). Power to the PTO switch will be disconnected after removing the
fuse F1 which will prevent the PTO clutch from engaging accidentally. Plug the
fuse back into the fuse block after servicing the cutting deck.
The blades of the cutting deck should come to a complete stop in less than 7
seconds after you disengage the PTO switch.
Note: When checking the blade stopping time, ensure that the deck is lowered
onto a clean section of turf or hard surface to prevent dust and unwanted material.
To check the blade stopping time, instruct a second person to stay away from
the machine at a safe distance and monitor the blades on the cutting deck.
Figure 216
3. Control panel cover
Page 7–4 Groundsmaster 7210
16222SL Rev C