Toro Groundsmaster 7210 Service Manual page 58

Installing the Engine (continued)
Diesel Engine: Service and Repairs
g035042
1. Glow relay
2. Start relay
7. Align the engine with the engine mounts that are attached to the frame with
the locknut (item 2 in
8. Install the engine to the flywheel housing with the 7 screws (item 17 in
16), 7 lock washers; torque the screws to 45.19 N·m (33.33 ft-lb). Follow
same procedure for verifying hose fitting torque. Paint mark screws prior to
final torque.
9. Install the guide bracket to the flywheel housing with the 2 screws (item 18
in Figure 16) and 2 lock washers; torque the screws to 45.19 N·m (33.33
ft-lb). Follow same procedure for verifying hose fitting torque. Paint mark
screws prior to final torque.
10. Remove all of the covers and plugs from the engine openings that you placed
while removing the engine.
11. Connect the fuel supply hose (item 4 in
fuel filter.
12. Use the notes that you recorded during removal and connect all the electrical
connectors.
• The machine wire harness to the engine wire harness (2 connectors) (item
6 in Figure 18).
• The engine wire harness to the Yanmar ECU (2 connectors) (item 2 in
Figure 18).
• The ground eye cable (bolt at the engine controller) (item 4 in
• The positive eye terminal (item 3 in
battery cable.
• The negative eye terminal (item 1 in
negative battery cable.
• The terminal receptacle at the coolant-temperature sender engine wire
harness: Connect the 1 socket connector (item 5 in
engine wire harness.
• The Glow, Start, and EGR Relays (items 1, 2, and 3 in
• The negative battery cable to the engine block (item 3 in
13. Install the radiator to the machine; refer to
14. Install the exhaust tube to the engine
Figure 20
3. EGR relay
Figure 16), snubbing washer, and screw.
Figure
Figure
Figure
Installing the Radiator (page
(Figure
Page 3–26
19) and return hose to the
Figure
18) at the clamp for the positive
18) at the clamp for the
Figure 18) of the
Figure 20).
Figure 17).
11).
Groundsmaster 7210
16222SL Rev C
Figure
18).
3–15).