Toro Groundsmaster 7210 Service Manual page 168

Installing the Gear Pump (continued)
Hydraulic System: Service and Repairs
3. Position the gear pump to the transmission and secure the pump with the
2 bolts and 2 lock washers.
4. Move the hydraulic tank toward the rear of the machine to its proper position
and assemble the tank to the reservoir support; refer to
Hydraulic Tank (page
5. Install the parking brake handle to the machine; refer to
Parking Brake Assembly (page
parking brake sensor is correct after you install the brake handle.
6. Remove the caps or plugs that were installed to the hydraulic hoses and
fittings during the removal process.
7. Use the labels that you attached during the removal process to correctly
connect the hydraulic hoses to the fittings on the gear pump and hydraulic
tank; refer to Installing the Hydraulic Hose and Tube (O-Ring Face Seal
Fitting) (page 4–5).
8. Fill the hydraulic tank with the correct quantity of new hydraulic fluid.
9. Install the operator seat and seat base; refer to
(page 6–36).
4–64).
6–16). Ensure that the operation of the
Page 4–108
Installing the
Assembling the
Installing the Operator Seat
Groundsmaster 7210
16222SL Rev C