Toro Groundsmaster 7210 Service Manual page 154

Assembling the Transmission (continued)
Hydraulic System: Service and Repairs
g033456
1. Bearing
2. PTO shaft
3. Spacer
11. Install the clutch assembly and gear onto the PTO shaft:
A. Install the key into the PTO shaft slot.
Note: Ensure that the rounded ends of the key are aligned with the
rounded ends of the shaft slot.
B. Slide the clutch assembly and gear onto the PTO shaft. Also, align the
rods in the clutch with the holes in the B-plate.
Note: Ensure that the slot in the clutch is aligned with the key in the shaft.
C. Place the spacer onto the PTO shaft.
D. Press the bearing onto the PTO shaft so that the bearing is flush with the
shaft shoulder.
g033457
1. Friction plate
12. Apply clean hydraulic fluid to the friction plate and place it in the transmission
pump housing.
Note: Ensure that the tabs on the friction plates are placed in the housing
grooves.
Figure 96
4. Gear
5. Clutch assembly
6. Key
Figure 97
2. Pump housing
Page 4–94 Groundsmaster 7210
16222SL Rev C