Removing the Operator Seat (continued)
Installing the Operator Seat
Chassis: Service and Repairs
2. Unlatch the operator seat and raise it.
To prevent injury, do not attempt to reach the seat switch through
the openings in the seat plate.
If seat switch service is necessary, remove the seat from the seat
plate to access the switch.
g033704
1.
Harness connector
2.
Latch angle
3. Disconnect the machine wire harness electrical connector from the seat
switch harness connector
4. Support the seat and latch angles to prevent them from shifting during seat
removal.
5. Remove the 4 flange nuts that attach the seat and latch angles to the seat
plate, and remove the seat from the machine.
6. Remove the seat parts as shown in
1. Install all the removed seat parts
2. Align the seat and latch angles to the seat plate. Secure the assembly with
the 4 flange nuts.
3. Connect the wire harness electrical connector to the seat switch harness
(Figure
212).
4. Lower the seat and latch it.
5. Check the operation of the operator seat switch.
WARNING
Figure 212
3.
Flange nut
(Figure
212).
Figure
(Figure
211).
Page 6–36
211.
Groundsmaster 7210
16222SL Rev C