Pto Driveshaft - Toro Groundsmaster 7210 Service Manual

PTO Driveshaft

g033694
1. Transmission assembly
2. Bolt (4 each)
Removing the PTO Driveshaft
Groundsmaster 7210
16222SL Rev C
3. Roll pin (2 each)
4. Locknut (4 each)
Note: The PTO driveshaft removal is easier if the machine is positioned on
a hoist.
1. Park the machine on a level surface, lower the cutting deck (or implement)
to the lowest setting, shut off the engine, set the parking brake, and remove
the key from the key switch.
2. Remove the fuse F1 (15 A) from the fuse block to prevent the PTO clutch
from engaging accidentally.
3. Disconnect the end yoke of the PTO driveshaft from the PTO shaft of the
transmission as follows:
A. Remove the roll pin from the end yoke and PTO shaft.
B. Loosen the 2 bolts and 2 locknuts.
C. Slide the driveshaft end yoke from the PTO shaft.
4. Disconnect the end yoke of the PTO driveshaft from the cutting deck gearbox
shaft as follows:
A. Remove the roll pin from the end yoke and gearbox shaft.
Figure 201
Page 6–25
5. PTO driveshaft
6. Cutting deck gearbox
Chassis: Service and Repairs