Toro Groundsmaster 7210 Service Manual page 296

Removing the Rollover Protection System (continued)
Installing the Rollover Protection System
Chassis: Service and Repairs
g036980
1. Vent hose (2 each)
3. Remove the 2 double loop hairpin cotters (item 10 in
fold pins and pull the fold pins from the ROPS support plate.
4. Remove the 2 screws (item 7 in
support plate, and remove the ROPS tube.
5. Remove the 3 swell latches (item 2 in
to the cross-member assembly, and remove the rear panel.
6. Disconnect the vent hose (item 1 in
7. Disconnect the oil breather (item 2 in
8. Remove the 4 screws (item 3 in
cross-member assembly to the ROPS tubes, and remove the cross-member
assembly.
1. Install the cross-member assembly (item 14 in
with the 4 screws and 4 flange nuts.
2. Connect the vent hose (item 1 in
3. Install the oil breather (item 2 in
4. Install the rear panel (item 1 in
with the 3 swell latches.
5. Install the ROPS support plate and ROPS tube with the 2 screws (item 7
in Figure 209) and 2 nuts.
6. Insert the 2 fold pins (item 6 in
insert the 2 double loop hairpin cotters.
7. Lower the operator seat.
Figure 210
2. Oil breather
Figure 209) and 2 nuts from the ROPS
Figure
Figure 210) from the top of each fuel tank.
Figure
Figure 209) and 4 flange nuts that secure the
Figure 210) at the top of each fuel tank.
Figure 210) to the hydraulic hose.
Figure 209) to the cross-member assembly
Figure 209) into the ROPS support plate and
Page 6–34
Figure 209) from the 2
209) that secure the rear panel
210) from the hydraulic hose.
Figure 209) to the ROPS tube
Groundsmaster 7210
16222SL Rev C