Neutral Switches - Toro Groundsmaster 7210 Service Manual

Neutral Switches

Testing the Neutral Switches
Groundsmaster 7210
16222SL Rev C
g035048
1. Left cover
2. Bolts
g033649
1. Traction lever (left)
The Groundsmaster 7210 machine uses 2 identical neutral switches. These
neutral switches are normally open and close when the traction levers are in the
N position. The neutral switches are located under the left cover
EUTRAL LOCK
and right cover below the operator seat
The Standard Control Module (SCM) monitors the status of the neutral switches.
If the key switch is in the O
position, the SCM Neutral input LED should be illuminated. The switches
LOCK
are connected in series so that the 2 switches must be closed for the neutral
input to be completed for the SCM.
1. Before you disconnect a neutral switch for testing, ensure that you test the
switch and its circuit wiring as a SCM input; refer to
(page 5–3).
Figure 152
3. Right cover
Figure 153
2. Neutral switch
(Figure 152
position and the 2 traction levers are in the N
N
Page 5–27 Electrical System: Testing the Electrical Components
and Figure 153).
EUTRAL
Standard Control Module