Toro Groundsmaster 7210 Service Manual page 301

Assembling the Operator Seat (continued)
Groundsmaster 7210
16222SL Rev C
3. Position the spring saddle on the spring arm and slide the saddle down.
Hook the spring ends on the top of the suspension base.
4. Use the suspension base as a pry point, place a prybar on the top of the
spring saddle and push the saddle down to elongate the springs to install the
bolt to the top of the shock absorber and suspension base. Align the bolt in
position with the nut.
5. Position the seat frame to the suspension base.
6. Align the bearing blocks on the frame with receivers on the suspension base
and guide frame into the place.
7. Insert the 2 bearing shafts and split nylon bushings to the suspension base
and frame, and install the bearing shafts with the 2 roll pins.
8. Position the cables under the seat frame bars and on the top of the
suspension base and insert the cable ends in the spring saddle slots.
9. Pass the weight adjustment knob shaft through the weight indicator, washer,
and seat frame hole.
10. Turn the knob shaft into the weight adjust bar and install the hex nut on the
knob shaft.
11. Position the seat boot to the seat frame and attach with the 18 push clips.
12. Position the bottom cushion to the seat frame and attach with the 2 bolts.
13. Position the back cushion to the seat frame and attach with the 6 push clips.
14. Assemble the back rest knob to the seat and attach with the nut. Attach
the label to the knob.
15. Assemble the back panel and then the armrest assemblies to the seat.
16. Install the operator seat on the machine; refer to
(page 6–36).
Page 6–39
Installing the Operator Seat
Chassis: Service and Repairs