Toro Groundsmaster 7210 Service Manual page 253

Removing the PTO Solenoid Valve Coil
Installing the PTO Solenoid Valve Coil
Groundsmaster 7210
16222SL Rev C
1. Park the machine on a level surface, lower the cutting deck (or implement),
set the parking brake, shut off the engine, and remove the key from the
key switch.
2. Raise the operator seat to get access to the PTO solenoid valve coil.
3. Disconnect the wire harness electrical connector from the PTO solenoid
valve coil connector.
4. Remove the nut from the spool assembly.
5. Slide the coil assembly from the solenoid valve stem
6. Clean any corrosion or dirt from the valve stem.
1. Slide the new coil assembly, seals, and washers onto the solenoid valve
stem. Ensure that you correctly position the seals and washers
When securing the solenoid valve coil to the solenoid, do not
overtighten the hex nut.
2. Install the hex nut onto the spool assembly and torque the nut to 5.9 to 7.8
N∙m (53 to 69 in-lb).
3. Connect the wire harness electrical connector to the solenoid valve coil
connector.
4. Lower and secure the operator seat.
IMPORTANT
Page 5–57
(Figure 181).
(Figure
Electrical System: Service and Repairs
181).