Toro Groundsmaster 7210 Service Manual page 274

Installing the Parking Brakes (continued)
Chassis: Service and Repairs
g033683
1. Brake swivel
2. Caliper brake lever
3. Wheel hub disc
7. Adjust the position of the brake support so that the clearance between the
wheel hub disc and the 2 springs in the parking brake is 0.8 to 1.7 mm (0.030
to 0.070 inch). When the clearance is correct, fully tighten the 4 bolts and
4 flange nuts (Figure
8. Install the brake rod assembly to the parking brake lever with the flat washer
and retaining ring.
9. Install the wheel to the machine with the 5 wheel-lug nuts.
10. Lower the wheel to the ground and torque the 5 wheel-lug nuts to 102 to 115
N∙m (75 to 85 ft-lb) in a crossing pattern.
11. If the wheel hub was removed, set the parking brake and torque the locknut
(item 1 in Figure 187) to 407 to 542 N∙m (300 to 400 ft-lb). Release the
parking brake.
12. Check the operation of the parking brake and parking brake sensor.
Figure 190
4. Hardened washer
5. Clearance
190).
Page 6–12 Groundsmaster 7210
16222SL Rev C