General Information; Standard Control Module - Toro Groundsmaster 7210 Service Manual

General Information

Standard Control Module

SCM Inputs
Groundsmaster 7210
16222SL Rev C
The Traction Unit Operator's Manual provides information regarding the
operation, general maintenance, and maintenance intervals for your machine.
Refer to the Traction Unit Operator's Manual for additional information when
servicing the machine.
g034387
1. Flange nut
2. Standard Control Module (SCM)
3. Screw
The Groundsmaster 7210 machine is equipped with a Standard Control Module
(SCM) to monitor and control the electrical components required for safe
operation. The SCM is attached to the control panel cover
The SCM monitors the inputs from the key, neutral, parking brake, PTO, seat,
and dual temperature switch. The SCM provides a Run and Start signal for
the Engine Controller to use.
Use the SCM to check the operation of the machine switches by monitoring the
SCM LEDs. If a SCM LED does not illuminate (e.g., the In seat input LED does
not illuminate when the seat is occupied and the key switch is in the O
you must test the switch, fuses, and circuit wiring.
The SCM does not connect to an external computer or hand held device, cannot
be re-programmed, and does not record intermittent fault data.
The power input LED should be illuminated when the key switch is in the O
position. The power input LED should also be illuminated when the key switch is
in the S position.
TART
The start input LED should be illuminated when the key switch is in the S
position.
The neutral input LED should be illuminated when the 2 traction control levers
are in the N
EUTRAL LOCK
The parking brake off input LED should be illuminated when you do not set
the parking brake.
Figure 133
4. Control panel cover
5. Latch
position.
Page 5–3
(Figure 133).
position),
N
Electrical System: General Information
N
TART