Testing the Diode Assembly (continued)
Resistor Assembly
Testing the Resistor Assembly
Electrical System: Testing the Electrical Components
Diode Test Table
Multimeter Red Lead (+)
on Terminal
Female
Male
The resistor assembly is used in all the engine wire harnesses for GM7210
machines that is necessary for operating the key switch. The resistor plugs into
the wiring harness near the alternator; refer to the Engine Wire Harness Drawing
in Appendix A—Foldout Drawings
The resistor assembly can be identified by its gray color and resistor symbol on
the end of the resistor assembly body.
g034715
1.
End of the resistor body
The resistor can be tested using a digital multimeter (ohms setting).
Note: The resistance across the resistor terminals should be 1600 ohms.
Multimeter Black Lead
(-) on Terminal
Male
Female
Figure 162
2.
Resistor assembly
Page 5–38
Continuity
Yes
No
Groundsmaster 7210
16222SL Rev C