Toro Groundsmaster 7210 Service Manual page 122

Charging the Hydraulic System (continued)
Hydraulic System: Service and Repairs
E. The gear pump that is damaged.
10. After the lift cylinder moves normally, proceed to step 11.
11. Operate the traction control levers in the forward and reverse directions.
The drive wheels should rotate in the proper direction. If the wheels rotate
in the wrong direction, shut off the engine, inspect the wheel motor location
and hydraulic lines to the wheel motors; refer to
(page 4–73).
12. Adjust the traction control levers to the N
Unit Operator's Manual.
13. Lower the machine to the ground.
14. If the transmission or a wheel motor was replaced or rebuilt, operate the
traction circuit on a level ground so that the 2 drive wheels rotate slowly
for 10 minutes.
15. Operate the machine by gradually increasing its work load to full over a 10
minute period.
16. Stop the machine. Check the hydraulic-fluid level in the hydraulic reservoir
and add correct quantity of fluid if necessary; refer to the Traction Unit
Operator's Manual.
17. Check the hydraulic components for leaks and tighten any loose connections.
EUTRAL
Page 4–62
Installing the Transmission
position; refer to the Traction
Groundsmaster 7210
16222SL Rev C