Servicing The Parking Brake - Toro Groundsmaster 7210 Service Manual

Servicing the Parking Brake

g033684
1. Lever
2. Assembly sleeve (2 each)
3. Hardened washer (2 each)
4. Hex bolt (2 each)
5. Mounting locknut (2 each)
6. Hex nut (2 each)
7. Stationary actuator
Disassembling the Parking Brake
Assembling the Parking Brake
Groundsmaster 7210
16222SL Rev C
8. Sleeve (2 each)
9. Steel ball (3 each)
10. Spring pin
11. Compression spring (2 each)
12. Mount sleeve (2 each)
13. Hex nut (2 each)
14. Mounting screw (2 each)
Note: If the parking brake wear or damage occurs, brake replacement is
necessary. Individual brake components are not available.
1. Loosen and remove the 2 hex bolts (item 4 in
screws, and 4 hex nuts.
2. Slide the inner and outer stators from the sleeves and stationary actuator.
3. Inspect the parking brake components. Replace the complete brake
assembly, if you find excessive wear or damage to any component.
1. Position the stationary actuator on the level work surface.
2. Assemble the brake components in order
Figure 191
15.
16.
17.
18.
19.
Page 6–13
Socket-head screw (2 each)
Outer stator (brake pad)
Inner stator (brake pad)
Shim
Washer
Figure 191), 2 socket-head
(Figure 191).
Chassis: Service and Repairs