Toro Groundsmaster 7210 Service Manual page 132

Removing the Transmission (continued)
g033420
1. Left wheel motor
2. Hydraulic tank
3. Gear pump
Hydraulic System: Service and Repairs
10. Remove the oil filter from the transmission and discard the filter. If necessary,
remove the gear pump from the transmission; refer to
Pump (page 4–106).
4. Right wheel motor
5. 8mm threaded boss
6. Transmission
Note: Two 8 mm eyebolts can be installed into the threaded bosses in
the top of the transmission to allow the use of a lift or hoist to remove the
transmission (Figure
Support the transmission assembly when you remove it from the
flywheel housing to prevent it from falling and causing personal
injury.
11. Remove the 7 bolts and 7 lock washers that secure the transmission to the
flywheel housing. Note the location of the shorter bolt for assembly purposes.
Ensure that you do not damage the transmission, flywheel housing,
hydraulic lines, electrical harness, or other parts while removing the
transmission.
12. Move the transmission assembly toward the front of the machine and away
from the flywheel housing and coupler on the engine flywheel. Lift the
transmission from the machine.
Figure 60
60).
CAUTION
IMPORTANT
Page 4–72
Removing the Gear
7. Flywheel housing
Groundsmaster 7210
16222SL Rev C