Releasing Pressure From The Hydraulic System - Toro Groundsmaster 7210 Service Manual

Releasing Pressure from the Hydraulic System

Groundsmaster 7210
16222SL Rev C
Release all the pressure in the hydraulic system before you work on the hydraulic
system.
•
Release the hydraulic pressure from the traction circuit as follows:
Note: If you park the machine on an incline or slope, the pressure in
the traction circuit does not release.
1. Move the machine to a level surface.
2. Lower the cutting deck (or implement).
3. Shut off the engine.
4. Turn the key switch to the O
•
Release the hydraulic pressure from the lift circuit as follows:
1. Fully lower the cutting deck (or implement) onto the solid blocks.
2. Turn the key switch to the O
3. After lowering the cutting deck, ensure that the lift cylinder does not
support the cutting deck (or implement).
position and allow the engine to stop.
FF
position and allow the engine to stop.
FF
Page 4–11 Hydraulic System: General Information