Toro Groundsmaster 7210 Service Manual page 87

Remote Starter Switch (continued)
Groundsmaster 7210
16222SL Rev C
g035022
1. Starter motor
2. Starter solenoid
After flushing the hydraulic system or replacing a hydraulic component (e.g.,
gear pump, piston pump, or wheel motor), it is necessary to prime the hydraulic
pumps. A remote starter switch
pumps. You can get this switch locally.
When using a remote starter switch, it is highly recommended to
include a 20 A in-line fuse between the battery and switch connector
for circuit protection.
A remote stater switch can also be constructed using the Toro switch #106-2027,
a length of 14 gauge wire, a 20 A in-line fuse, 2 alligator clips, and necessary
connectors. Connecting the wire to switch terminals 1 and 2 will allow the
momentary switch contacts to be used for the remote starter switch
Note: For information on using the remote starter switch to prime the hydraulic
pumps; refer to Flushing the Hydraulic System (page
Figure 39
3. B+ terminal
(Figure 37) can be used for priming the hydraulic
IMPORTANT
Page 4–27
(Figure 38).
4–59).
Hydraulic System: Special Tools