Deck Lift/Lower Switch
Electrical System: Testing the Electrical Components
g035037
1.
Right traction lever
The deck lift/lower switch is used to raise and lower the cutting deck of your
machine. The switch is attached to the right traction lever
lift/lower switch is connected to the switch wire harness that runs through the right
traction lever and connects to the main wire harness below the control panel.
When the top of the lift/lower switch is pressed (momentary position), both of
the solenoid valve coils (S1 and S2) on the hydraulic lift control manifold are
energized causing the valves to shift and the lift cylinder to extend to raise the
cutting deck. When the bottom of the lift/lower switch is pressed (detent position),
solenoid valve coil S1 on the hydraulic lift control manifold is energized causing
the valve to shift and the lift cylinder to retract to lower the cutting deck.
Figure 174
2.
Deck lift/lower switch
Page 5–50
(Figure
174). The
Groundsmaster 7210
16222SL Rev C