Toro Groundsmaster 7210 Service Manual page 41

Removing the Air Cleaner System (continued)
Installing the Air Cleaner System
Groundsmaster 7210
16222SL Rev C
g034294
1. Service indicator
2. Housing
3. Cover assembly
4. Vacuator valve
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Unlatch the hood and raise it.
3. Remove the air cleaner components as shown in
4. Examine the air cleaner housing and cover for wear or damage that could
cause possible air leaks.
Leaks in the air filter system will allow dirt to enter into the engine
and can cause serious engine damage. Ensure that all the air cleaner
components are in good condition and are properly secured during
installation.
5. Examine the air inlet hoses for wear or damage, replace the hose that is
worn or damaged.
6. Inspect and replace the damaged hood seals.
1. Assemble the air cleaner system as shown in
A. Ensure that the vacuator valve (item 4 in
installation.
B. Ensure that the inlet hose (item 7 in
all the points after you complete installation of air cleaner.
C. If the service indicator (item 1 in
the housing, apply sealant to the threads of the nipple, torque the nipple
to 3.4 N·m (30 in-lb), and install the service indicator onto the nipple.
2. Lower the hood and secure it with the latches.
Figure 9
5. Air filter
6. Gasket
7. Air cleaner bracket
8. Nipple
IMPORTANT
Figure
Figure 9) and nipple were removed from
Page 3–9
Figure 8 and Figure
Figure 8 and Figure 9.
Figure 9) is pointed down after
8) has clearance around it at
Diesel Engine: Service and Repairs
9.