Toro Groundsmaster 7210 Service Manual page 144

Disassembling the Transmission (continued)
Hydraulic System: Service and Repairs
38. Remove the thrust plate from each swash plate. For assembly purposes,
note that the beveled sides of the thrust plates are against the swash plate
surfaces.
39. Remove the socket-head screw and nut that secures the control arm onto
each trunnion shaft. Slide the control arm from each trunnion shaft.
g033437
1. Hex plug
40. Remove the 2 hex plugs and 1 socket head plug from the gear case housing.
41. Remove and discard the O-rings from the plugs.
g033438
1. Gear case housing
2. Pump housing
42. Remove the 15 flange-head screws that attach the gear case housing to the
transmission pump housing.
43. Carefully remove the gear case housing from the pump housing.
44. Locate and retrieve the 2 pins from the gear case housing holes.
45. Remove and discard the gasket.
Figure 77
2. Socket head plug
Figure 78
3. Pin (2 each)
Page 4–84 Groundsmaster 7210
16222SL Rev C