Toro Groundsmaster 7210 Service Manual page 133

Removing the Transmission (continued)
Installing the Transmission
g033421
Groundsmaster 7210
16222SL Rev C
13. Locate and note the location of the 2 dowel pins from the transmission and
flywheel housing.
14. On both sides of the transmission, remove the retaining ring that secures the
pump control rod end onto the transmission control arm
the control rod from the control arm.
15. If the hydraulic fittings are to be removed from the transmission, put a mark
on the fitting orientation for correct assembly. Remove the hydraulic fittings
from the transmission as necessary. Discard the fitting O-rings.
16. Inspect the flywheel housing and coupler on the engine flywheel for wear
or damage.
1. Ensure that the flywheel coupler and flywheel housing are secure on the
engine; refer to Chapter 3: Diesel Engine (page
2. If the hydraulic fittings were removed from the transmission, lubricate and
install new O-rings onto the fittings. Install the fittings into the transmission
ports; refer to Installing the Hydraulic Fittings (SAE Straight Thread O-Ring
Fitting into the Component Port) (page
values identified in
3. If the gear pump was removed from the transmission, install the gear pump;
refer to Installing the Gear Pump (page
4. Slide both the pump control rods onto the transmission control arms and
attach them with retaining rings
4–7). Tighten the fittings to the torque
Figure 61.
4–107).
(Figure 59).
Figure 61
Page 4–73
(Figure 59). Slide
3–1).
Hydraulic System: Service and Repairs