Assembling the Parking Brake Assembly (continued)
Groundsmaster 7210
16222SL Rev C
g033688
1.
Rear brake rod
2.
Compression spring
3.
Flat washer (2 each)
2. After you assemble the brake system, set the parking brake and check the
length of the compression spring on the rear brake rod.
Note: Ensure that the length of the spring with the brake applied is 7.4 to 7.6
cm (2.880 to 3.000 inch). If necessary, adjust the length of the spring with the
front hex nuts (item 6 in
3. Check the operation of the parking brake and parking brake sensor.
4. Install the left cover to the machine with the 2 bolts
Figure 195
4.
Rear hex nut (2 each)
5.
Swivel
6.
Front hex nut (2 each)
Figure
195) on the rear brake rod.
Page 6–17
(Figure
193).
Chassis: Service and Repairs